Ground Rod Hammer Drill

I m sure the drill couldn t take much of that abuse but it was over 90 degrees at the time.

Ground rod hammer drill.

All except the last can be picked up with one hand. As someone who has sunk them both manually and with the hammer drill. We just chucked up the rod like a bit set the drill to hammer only and drove it home. Driving a ground rod into the ground can take a long time and can.

It is ideal for installing ground rods parking bumper stakes. I drove in 5 rods in 2015 and in august 2016 was putting in 14 more. August 15 2016 on rod 11 the driving head just snapped off and i came very close to impaling myself on that ground rod since i was over it. It only takes a minute of two to get the hang of it.

The drilling action of a hammer drill or rotary hammer buys you nothing. My average time is less. The electrical code states that it must have 8 feet 2 4 m of contact with the ground so you need to drive it all the way down. The demo hammer almost always works.

Pull the drill out and just drop the ground rod in. It took longer than with the big roto hammer but less effort than swinging a sledge hammer. I have a makita demolition hammer with a ground rod driver attachment. The hammer weighs around 40lbs and i can drive a ground rod through rock in one minute.

I highly recommend it. When driving ground rods i ve gotten lucky with one of the lighter duty tools. It did not have any bits to do this. Milwaukie hammer drill and a hole saw without a pilot bit.

You need to drive your rod all the way into the ground. I have had this for about for over a year using it with my dewalt sds max hammer drill driving in 5 8 ground rods. This is compatible with sds max demolition hammers and rotary hammers with chipping function. Note that because it s just a smooth pointed rod a ground rod doesn t need to be rotated.

The hammer drill could not be set to hammer only so it tried to spin the rod some. I could have never completed this job without the bosch rh432vcq 1 1 4 inch sds plus rotary. The drill is the way to go. This was a pretty tough install with all the rock i encountered.

At the electrician i worked for we had a spline drive rotary hammer drill that we used to drive ground rods. The downside is 800 00. From then on you can drill an eight foot hole in about a minute to two minutes. Using your hammer drill or driving tool gradually drive the rod vertically into the ground.

Forcing the drill can plug the end or in some cases bend the conduit.